FirstSpear

PEO Soldier Reminds You To Use Lithium Batteries

October 23rd, 2014

We recently had an opportunity to speak with several representative from Program Executive Officer Soldier’s Program Manager for Soldier Sensors and Lasers about their push to remind Soldiers to use Lithium batteries with their equipment. Specifically, they are advocating the use of the L91 AA battery, which is available through the standard stock system under NSN 6135-01-333-6101 (12 per package). It is common to a wide variety of Soldier equipment including the Enhanced Night Vision Device and Thermal Weapon Sight.

There are several advantages to using the L91 AAs. Mr. Joe Pearson, PM SSL Logistics Management Division Director articulated several reasons Lithium batteries are preferred over the cheaper Alkaline models. First off, the Technical Manual calls for their use, and here’s why. Bottom line up front; L91 batteries offer improved lethality and maneuverability through decreased operational load and longer performance. Since they last three to five times longer, there is less equipment down time due to battery swaps. This increased life also results in reduced supply costs. While alkaline batteries are less expensive when you compare them one-to-one to the Lithium versions, the Lithium battery will last three times as long as the Alkaline. That’s one third the cost. Additionally, Lithium batteries are 37% lighter than Alkaline batteries resulting in less cost to the total supply chain for transportation. That means fewer aircraft in the air and fewer vehicles on mined roads. Finally, you can’t go wrong with the L91 batteries. They have a shelf life of up to 15 years.

TWS Battery Use

If those reasons weren’t enough, SSG José R. Salcedo III, S3, Tasking NCO, 2-504 PIR, 1st Brigade, 82nd Airborne Division related an incident that is germane to the subject. During a 2012 vehicle patrol in Afghanistan’s Ghazni Province when one of his convoy’s vehicles struck an IED. He assumed a security posture scanning for the enemy with his Thermal Weapon Sight. Specifically, he was looking for the trigger man who initiated the IED explosion. He had just checked the battery indicator about 10 minutes before which indicated he had about half of his power left. But once he placed it into operations, the screen went blank. In the moments it took him to swap batteries, SSG Salcedo fears his target slipped away. Turns out, his TWS was powered that day by an Alkaline battery. The battery indicator on the TWS is calibrated for use with Lithium batteries. Now, he only uses L91 Lithium batteries.

Battery usage

The image above gives you a good idea of the advantages of lithium over alkaline batteries. As you can see, their operational life is affected by temperature. According to MSG Reiko Carter, PM SSL NCOIC/Fielding OPS NCO, specific performance data based on temperature is available in each piece of equipment’s Technical Manual and they go over the data during New Equipment Training. However, there’s a lot of turnover in units and the guy who attended NET may have moved on. I think it would be a great project to produce an app that aggregates all types of equipment and battery usage data into a predictive planning tool for logistics and small unit leaders.

Please pass this info on to your logistics team if they haven’t seen it. Use of Lithium batteries won’t only save money but also increase your effectiveness and decrease your load in the field.

U.S. Tactical Supply Is Present At The 2014 International Sniper Competiton

October 23rd, 2014

U.S. Tactical Supply is present at the 2014 International Sniper Competition as a sponsor.

The 2014 International Sniper Competition, hosted at Fort Benning, Georgia, brings 35 teams (70 snipers) from all over the world to participate in 10 to 15 sniper related events. The focus of the competition is to bring teams together to share battlefield lessons learned, provide training initiatives and ideas and to compete tactically and technically. Unit coaches, commanders, and spectators are also in attendance.

The competition takes place from October 20th through 24th.

www.armysniper.org/international-sniper-comp

KCRF Resupply Complete!

October 23rd, 2014

IMG_8554.JPG

We’ve finally received a resupply on the giveaway KCRF patches made for us by Flexsystems which we give away at trade shows. See you at a show soon!

Rail Riders Bushwacker Weather Pants

October 23rd, 2014

I ran across these and thought they were cool. I don’t own a pair but I’ve had Rail Riders clothing in the past that is both comfortable and tough.

IMG_8539.JPG

2ply 3oz Duralite Nylon
Tough Railtex reinforced Seat, knees and back of ankles
Deep front pockets with side zippered security pocket
2 Zippered back pockets
Slanted cross-quad zip-pockets on each leg for easy access and storage
Articulated cell phone pocket
Articulated knees for great fit
D-ring on front belt loop for clipping keys, carabiners, etc
Boot-Cut width cuff
Slotted button closure with 7″ fly
Belt loops to fit a 2″ belt

Available in Khaki, Sage or Slate sizes Small – XXLarge in varying inseams.

www.railriders.com

Wilcox Industries – Dual Powered Aviation Mount

October 23rd, 2014

We checked out the new DPAM at AUSA. It allows power directly from the mount or via the cable to a rear mounted battery box.

Wilcox Improved Design For Aviation NVG’s to Fit Flight Helmets

Newington, NH-Wilcox has designed a Dual Powered Aviation Mount (DPAM) for use by Aviators and crewman that offers an overall improvement to the current existing systems and integrates into a flight helmet. The DPAM mount works with the ANVS-6/9, F4949, F5050 and GPNVG night vision goggles.

IMG_8267.JPG

This mount fully integrates into the currently used external batteries utilizing a standard 4-pin Lemo connector or can run off an internal 123A lithium battery for up to eight hours. The internal backup battery provides power to the NVG even when removed from the mount. This completely eliminates the need for the snap on battery pack and the additional weight. This system comes with the option of a permanent Wilcox 4-hole HMI or a Quick-Release 4-hole HMI that mount into the visor.

Unique features of the DPAM include a low-battery indicator light and a Power Mode selection that allows the operator to choose between the external and internal power supply without having to remove the helmet. The system has a switch guard that protects against accidental snags. The mount includes a clip that attaches to the visor to secure the power chord out of the way.

An NVG flip button allows the goggle to “flip up” into a stowed position when not in use. This enables the auto-off capabilities of the goggle helping to save battery life. The system has several adjustment points for a precise fit. An interface plate provides a stable mounting platform and helps with the fit. It also allows the DPAM to easily be removed from the shroud.

The mount is manufactured from lightweight aerospace grade metal and high strength polymer. A field replaceable ball detent insert provides the ability to set tolerances over the life of the mount. The mount fist into ballistic and non-ballistic helmets drilled with the standard one or three-hole pattern and when used with Wilcox’s line of NVG shrouds. The mount and shroud weigh a minimal 5.92 ounces.

For ordering and pricing information contact Wilcox Industries at www.wilcoxind.com.

IWI Galil ACE In 7.62×39 To Be Released For US Market

October 23rd, 2014

ACE 1

Military Arms Channel, through their Facebook page, revealed that IWI will be importing the Galil ACE in 7.62×39 for the US market. It will initially be available as a pistol with a side folding SB15 brace starting February 2015. Pictured is the SBR variant that the pistol will be based on.

ACE 2

It was also mentioned that IWI will be offering a 16″ barreled variant a month later in March.

Stay tuned for further details as they are revealed.

All pictures and information came from the Military Arms Channel Facebook page: www.facebook.com/militaryarms

www.iwi.us

A Message from Tom Hardy Regarding Help for Heroes

October 23rd, 2014

British actor Tom Hardy is a big supporter of Help for Heroes.

www.hotshotscalendar.com

Crosman – Benjamin Armada PCP Air Rifle

October 23rd, 2014

rifle-1

The Benjamin Armada is a .22 caliber pre-charged pneumatic rifle which features a Magpul M-LOK modular accessory system forend. According to the manufacturer, the Armada is the first commercially available PCP rifle that “allows shooters the same breadth of modularity and user configurability as enjoyed by the AR community.” It achieves this through the aforementioned M-LOK forend, as well as designing the rifle to Mil-Spec dimensions for the grip and stock interfaces.

The Armada is capable of delivering velocities of up to 1000 FPS with 32 foot pounds of energy. Included is a 10-shot magazine. The rifle features full suppression, and is capable of 30 shots per fill. The receiver has a machined Picatinny rail, and the bolt is reversible for left-handed shooters. Also included is an on-board gauge and two-stage trigger.

Unfortunately, the images aren’t showing the production model. Rather, it’s a special one-of-a-kind model that’s currently up for auction on Gunbroker through November 2nd, with the proceeds going to benefit the Navy SEAL Foundation. The package contains:

– Magpul M-LOK Modular Locking System
– Magpul PRS (Precision Rifle / Sniper) adjustable stock
– Magpul MBUS Pro Sight front and rear
– Magpul MIAD GEN 1.1 Grip Type 1
– Magpul M-LOK Cantilever Rail / Light mount
– Surefire Scout weapon light
– Tarjac Multi-Cam finish
– Zeiss TERRA 3x 4-12×50 mm scope
– Telescoping bipod
– 3 removable/configurable, M-LOK compatible handguards
– Custom embroidered Benjamin rifle case

The Armada is built in America.

For more information on the Benjamin Armada, and the auction, visit www.crosman.com/nsfauction